![Red Card :redcard:](./images/smilies/redcard.gif)
They're doing the junket prac this week, & I was determined to have clean waterbaths at the end of it so I played around with a few things & came up with this:
It cost $10.90 for a huge piece of polystyrene from Clark Rubber, & I found the short length of downpipe from Bunnings to cut the holes for $1.99.
Just cut the styrene to rough size with a hot knife, trim for a snug fit inside the waterbath, then heat the piece of downpipe in a bunsen & cut a few holes at a time. Took about an hour to do 4.
6 classes have used it so far & no spills
![Yahoo :yahoo:](./images/smilies/yahoo.gif)