How do you mix your chemicals

polling is enabled in this forum.
Post Reply

How do you work?

Poll ended at 25 Apr 2012, 08:14

Or mix solid in little beaker and then top up to the volume you require.
37
71%
or Put distilled water in beaker then add solid & mix?
15
29%
 
Total votes: 52

User avatar
Labbie
Posts: 3234
Joined: 28 Nov 2006, 10:00
Job Title: Retired
Suburb: At Home
State/Location: NSW

How do you mix your chemicals

Post by Labbie »

My two young ladies have asked, if their traineer has told them a old way or not.
Regards Labbie

Lab Manager/Lab Tech, mind reading etc etc
Now retired :wub:
User avatar
DavidPeterson
Posts: 196
Joined: 02 Apr 2012, 12:19
Job Title: STEM Resource & Lab Manager
School: Murray Bridge High School
Suburb: Murray Bridge
State/Location: SA

Re: How do you mix your chemicals

Post by DavidPeterson »

I do both..it depends on the solubility of the solid you are trying to dissolve. If it is highly soluble, add water to the solid. If it isn't as soluble, you may form larger lumps that become very difficult to fully dissolve.
DCP 8-)
STEM Resource @ Laboratory Manager
RPAS (Drone) Pilot
User avatar
kimmy
Posts: 418
Joined: 01 Jun 2006, 10:00
Job Title: School Lab Assistant
School: Quirindi High School
Suburb: Quirindi
State/Location: NSW

Re: How do you mix your chemicals

Post by kimmy »

Depends on what I am mixing :?: - no set rule for all chemicals.

I think for a new labbie as bad as this is it is alot of trial and error. Most of us have been thrown in the deep end at one stage and all manage to come out - maybe a few extra wrinkles but always smiling.

Just remember there are worse jobs in the school.

KIMMY
RosalieM
Posts: 1795
Joined: 20 Mar 2007, 10:00
Job Title: Lab Assistant
Suburb: Tamworth
State/Location: NSW

Re: How do you mix your chemicals

Post by RosalieM »

Usually I add water to the solid, mainly for convenience because then you weigh the solid in the beaker and add water, one beaker = less washing up.

However, for acid you must always add the acid to the water.

Also, for some solids when you add water they get really hot or really cold so when mixing those ones I generally add the solid to the large amount of water to avoid burns (if I remember!!!).
User avatar
smiley
Posts: 1398
Joined: 20 Nov 2006, 10:00
State/Location: QLD

Re: How do you mix your chemicals

Post by smiley »

Wa-a-a-ay back last century when I did a Lab TECHNICIAN'S Certificate, we were taught to always add solid to SOME distilled water and mix, then make up to the correct volume. I still do this, especially when I'm busy, and using a magnetic stirrer. I weigh out the solid, chuck it in a beaker or a flask with about 1/2 the required H2O, then let it stir while I get a volumetric flask ready/take a phone call/answer the prep room door/split an atom...whatever.
Cheers, K 8-)
User avatar
sunray18
Posts: 1488
Joined: 14 Feb 2008, 12:30
State/Location: NSW

Re: How do you mix your chemicals

Post by sunray18 »

It all depends on what it is... I often use a small amount of cold distilled/demineralised water to make a paste of the chemical in a large beaker, then boil distilled water in the electric jug and stir it into the paste - often the chemical dissolves immediately.
Post Reply